P 9
Please retain product label and instructions for future reference
14
Step 12
Parts needed - No. 14 QTY 90
Place the first two roof
boards (No. 14) onto the assembly
on each side, making sure the
boards are flush to the end of the
roof purlin. Once in position fix to
each purlin using 3x40mm screws.
Due to natural occurences of wood
shrinkage / expansion. You maybe
required to use the provided spac-
ers and place a space of 2mm to
ensure every roof board lines up
with the truss’.
*Ensure the roof boards meet
at the top of the apex and leave
an overhang at the bottom.
Continue adding the roof boards
along the roof, fixing each one into
position using 3x40mm screws,
making sure that each board is
interlocked, flush at the bottom &
meet at the top of the apex.
The last board on each side
will overhang: Using a staight edge
and a pencil mark out a line as
a guide.
Cut along the pencil mark and
remove the excess. Place the
cut down boards back onto the
roof and secure into place
using 3x40mm screws per
board.
*Please Note:
This image is for
illustrative purposes and may differ
from your choice in product.
Nevertheless the process of cutting
and fitting the last roof boards is the
same.
270x40mm Screws
40mm
screw
Pre drill
hole
*Cut to fit
23b
14
14
28
19
19
19
Step 13
Parts needed - No. 19 QTY 4
Ensuring the roof boards are
flush at the overhanging side and
meet at the apex, fix the Eaves
Frames (No. 19) to the underside
of the roof boards using 9x40mm
screws as shown in the
illustration.
*Please Note:
This image is for
illustrative purposes and may
differ from your choice in product.
Nevertheless the process of fixing
the eaves frames is the same.
36x40mm Screws
40mm
screw
Pre drill
hole
a
b
a
b
