5.4
Inject the dose as you were trained to do by your doctor or nurse
•
Slowly push the needle into the skin entirely (1).
•
Press the dose knob down as far as it will go
and hold it to
complete the full injection.
•
Hold the dose knob down for a minimum of 5 seconds to ensure
you inject the full dose (2).
•
The dose number shown in the dose display will turn back
to ‘0’. This shows that the complete dose was delivered.
•
After a minimum of 5 seconds, pull the needle out of the skin
while keeping the dose setting knob pressed down (3).
•
Release the dose setting knob.
6.
After the injection
6.1
Check that the dose display shows ‘0’
•
This confirms that the dose has been fully delivered.
Do not attempt to inject a second time.
•
In case the dose display doesn’t show 0, please contact your doctor or pharmacist.
