BT-1 PARTS REPLACEMENT
INSTRUCTION
WARNING
DISCONNECT TOASTER FROM
POWER SOURCE
BEFORE ATTEMPTING ANY
SERVICE PROCEDURE.
General information
The information on the following pages will describe
how to replace the most common components of the
BT-1 Toaster. Though the instructions are easy to
follow, the work should be done
ONLY
by a qualified
service technician. All replacement procedures will
first require the removal of one or both toaster side
panels, and top or bottom covers.
IMPORTANT:
When removing or replacing the bottom toaster
cover, it is extremely important that it be posi-
tioned correctly. The open side air cooling vent
should be facing towards the front of the unit.
This will assure proper air circulation and toaster
perfornmance.
A Panel Removal
1. The right and left side panels are each secured to
the toaster by one sheet metal screw located at
the back of the unit. Remove this screw and slide
out the panel.
When replacing either panel, be sure that the
panel is properly positioned in the securing track.
2. The top cover is also held in place with one sheet
metal screw. Remove this screw and slide the top
cover towards the back of the toaster. When
replacing the top cover, be sure that it is properly
positioned in the securing tracks.
3.
The bottom cover is secured by two sheet metal
screws. Remove these screws and pull towards
the front of the toaster.
NOTE PROPER
ORIENTATION OF THE OPEN SIDE OF
THE AIR COOLING VENT.
This opening
must always face towards the front of the unit to
assure proper toaster performance.
B Main Power On/Off Switch
(Figure 1 & 2)
1.
Remove the bottom cover.
2.
Disconnect the 2 wires at the on/off switch
terminal ends. Note the correct orientation of the
wires.
3.
Remove the rubber on/off switch boot (old style
units) and the black plastic mounting bezel.
4.
The on/off switch can now be removed from the
back of the control panel.
5.
Reverse this procedure to install a new switch.
(Refer to wiring diagram)
2
