Assembling Pedestal
The pedestal is designed to cover the underside area and legs of the tanning bed. The
pedestal comes in three pieces (2 sides, 1 front), with Velcro affixed to the sides. Begin
by placing the smaller sections (sides) of the pedestal next to the legs with the Velcro
towards the front. Remove the Velcro film. Place the front pedestal over the fronts of
the pedestal sides and affix to the Velcro.
Making the Electrical Connections
–
see electrical requirements.
(Refer to table of contents.)
WARNING! Be sure electrical power is disconnected before connecting the
canopy to bench cables.
Step 1. Connect the canopy to the bench power cord located on the back of the unit.
Step 2. Plug the three-prong 120VAC power cord into a 15 Amp dedicated outlet.
NOTE: IT IS BEST TO UNPLUG THE TANNING BED WHILE
NOT IN USE.
DO NOT CONVERT THE POWER CORD TO A TWO PRONG
CORD OR USE ANY EXTENSION CORD.
AS RECOMMENDED FOR ALL ELECTRICAL APPLIANCES,
THIS TANNING BED SHOULD NEVER BE OPERATED NEAR
WATER OR WHILE YOU ARE WET.
www.mercola.com
11
We do not recommend that you connect your tanning system to an extension cord.
However, if you must use an extension to reach your dedicated outlet, then it
must be a 3 wire extension cord of at least # 12 gauge wire for under 12 feet. If longer
than 12 feet, then you will need a 3 wire 10 gauge extension cord. (good to 25-30 ft.)
