Attaching Arms to Bench – Figure 1b
Attach the left arm (A) and the right arm (B) with the two allen bolts (E) to the bench
(Figure 1b). Use the allen wrench (I) to tighten. Do not over tighten, doing so may cause
damage.
Attaching the Canopy to Bench – Figure 1c
Note: To make attaching the canopy to the bench easier, you may want to place some of
the packing foam from the carton across the bench rails to protect the acrylic and support
the weight of the canopy when attaching it.
Step 1. Two people are required for this step. Before lifting the canopy over the bench
for placement, it is much easier to have the allen bolt ready in hand.
Step 2. With one person at each end of the canopy unit, lift up the canopy above the
bench and align the allen bolt holes from the canopy with the arms. Slip the
allen bolt (E) through the aligned holes. Tighten bolt with the allen wrench.
To avoid damaging the threaded inserts, do not over tighten.
Do NOT lower canopy until both gas shocks have been installed
www.mercola.com
9
