VELVET DRIVE IN-LINE AND V-DRIVE TRANSMISSION
SERVICE MANUAL NUMBER 24
90-861327--1 OCTOBER 1999
Page 8A-9
5. Install plastic strainer tube with the notch DOWN and OUT toward the side of the case.
71306
a
b
a -
Plastic Strainer Tube
b -
Notch
6. Install spring.
7. Coat bushing threads with Quicksilver Perfect Seal. Install and torque bushing to 25 lb-ft
(34 Nm).
8. Coat elbow fitting threads with Quicksilver Perfect Seal and install in bushing. Tighten
securely.
9. Reconnect hose and tighten securely.
Filling Transmission
IMPORTANT: Use only specified transmission fluid. Refer to “Specifications.”
1. Remove dipstick. Fill transmission with fluid, through dipstick hole, to bring up to full
mark.
72526
a
b
c
a -
Dipstick
b -
Full Mark
c -
Dipstick Tube
IMPORTANT: To accurately check fluid level, run engine at 1500 rpm for 2 minutes
immediately prior to checking level.
2. Start engine and run at 1500 rpm for 2 minutes to fill all hydraulic circuits.
NOTE: Be sure to push dipstick all the way down into dipstick tube when checking fluid level.
3. Stop engine and quickly check fluid level. Add transmission fluid, if necessary, to bring
level up to full mark on dipstick.
4. Reinstall dipstick. Be sure to tighten T-handle securely.
Index