HURTH TRANSMISSIONS
SERVICE MANUAL NUMBER 24
Page 8C-12
90-861327--1 OCTOBER 1999
Filling Transmission
IMPORTANT: Use only fluid recommended in “Fluid Specifications.”
1. Fill transmission to proper level, through oil filter cavity. Capacities are listed in “Fluid
Specifications.”
2. Install filter as follows:
a. Coat O-ring on filter cover with transmission fluid.
27662
a
b
a -
Filter Cover
b -
O-Ring
CAUTION
Transmission fluid filter and cover must be properly seated to avoid fluid foaming
and/or loss of fluid, thus resulting in decreased efficiency and/or damage to trans-
mission.
b. Push down until cover is fully seated (top of cover flush with housing), then, Turn
T-handle clockwise until tight.
27666
a
a -
Set Screw (Later Models)
Index