Section 5 - Maintenance
Page 60
90-899883182 NOVEMBER 2007
Engine Oil
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by
law. Use caution not to spill oil, coolant, or other fluids into the environment when using
or servicing your boat. Be aware of the local restrictions governing the disposal or
recycling of waste, and contain and dispose of fluids as required.
Checking
1. Stop the engine and allow the oil to drain into the oil pan for approximately five minutes
with the boat at rest in the water.
2. Remove the dipstick, wipe it clean, and install it into the dipstick tube. Wait 60 seconds
to allow trapped air to vent.
32706
b
c
a
a -
Dipstick
b -
Maximum mark
c -
Minimum mark
3. Remove the dipstick and observe the oil level, which must be between the maximum
and minimum marks on the dipstick. Add oil if necessary. See
Filling
.
4. Install the dipstick into the dipstick tube.
Filling
IMPORTANT: Do not overfill the engine with oil.
Summary of Contents for Vazer 100
