Section 5 - Maintenance
90-899883182 NOVEMBER 2007
Page 61
IMPORTANT: Always use the dipstick to determine the exact quantity of oil or fluid required.
1. Remove the oil fill cap.
26212
a
a -
Oil fill cap
NOTE: Adding 0.95 liters (1 quart) of engine oil will raise the level from the add mark to the
top of the OK range.
2. Add the specified engine oil to bring the level up to, but not over, the Maximum mark
on the dipstick.
Engine Model
Capacity
Fluid Type
Vazer 100 with Emissions
Control
4.02 liters (4.25 U.S. Quart)
Mercury Full‑Synthetic MerCruiser
20W‑40
3. Check the oil level. See
Checking
.
4. Replace the fill cap.
Changing Oil and Filter
See
Maintenance Schedule
for the change interval. Engine oil should be changed before
placing the boat in storage.
IMPORTANT: Change engine oil when the engine is warm from operation. Warm oil flows
more freely, carrying away more impurities. Use only recommended engine oil (refer to the
Specifications section).
Easy Engine Oil Drain System
NOTE: The boat must be out of water to perform this procedure.
1. Loosen the oil filter to vent the system.
2. Allow sufficient time for the oil to drain from the filter down into the engine block.
3. Remove the bilge drain plug.
Summary of Contents for Vazer 100
