5. Cold Temperature ‑ It may be helpful to prime the engine 1 to 3 times
using the manual primer knob before starting.
29013
IMPORTANT: Electric starting outboard models must not be started manually
using the starter rope, or run, without having the battery leads connected to a
battery. Damage to the charging system could result.
6. Cold Engine ‑ Do not advance the neutral fast idle speed feature on the
remote control for initial starting. After engine has started, slowly advance
the fast idle speed feature to increase idle speed until engine is warmed
up. Keep engine speed below 2000 RPM.
27242
7. Warm Engine ‑ Advance the fast idle lever or throttle only feature to an
approximate halfway (1/2) setting. After engine starts, immediately reduce
engine speed back to idle.
a -
Fast idle speed lever
b -
Throttle only feature
8. Starting Flooded Engine ‑ Advance the fast idle lever or throttle only
feature to the maximum position. Without activating primer, crank engine
for 10 seconds. Wait 30 seconds and repeat until engine starts.
Immediately start to reduce engine speed after engine starts.
3030
a
b
OPERATION
eng
39
Summary of Contents for 10 Marathon
Page 2: ...eng ...
Page 6: ...eng iv ...