INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
23
ArtNo.010-0004 Moving the cooker
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut
(Fig. 7.5)
. Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the pack base tray. Open the grill
door and right-hand oven door so that you can get a good
grip on the bottom of the fascia panel as you move the oven
(Fig. 7.6)
.
Carefully push the cooker backwards off the pack base.
Remove the pack base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it.
n
n
DO NOT use the door handles or control knobs to
manoeuvre the cooker.
Fitting the Flue and Vent
Fitting the Flue
Remove the four screws from the grill flue opening.
Offer the removable flue up to grill flue opening. Making sure
that the removable flue bottom flange fits inside the fixed
flue, secure in place with the four screws
(Fig. 7.7)
.
Fitting the Vent
The larger of the holes along the sides are for screwdriver
access and should face to the rear
(Fig. 7.8)
. Use the screws
and nuts supplied to hold the vent in place.
Conversion to Another Gas
If the appliance is to be converted to another gas do the
conversion at this point. See the conversion section of these
instructions.
Fig. 7.5
Fig. 7.6
Fig. 7.7
Fig. 7.8
Summary of Contents for 1082 Dual Fuel
Page 1: ...1082 Dual Fuel USER GUIDE INSTALLATION INSTRUCTIONS ...
Page 4: ...ii ...