Note:
There are 30 seconds in which to initiate step eight.
8. Return to the vehicle and firmly press, hold for two seconds and
release the HomeLink
威
button. Repeat the press/hold/release sequence
again, and, depending on the brand of the garage door opener (or other
rolling code equipped device), repeat this sequence a third time to
complete the programming.
HomeLink
威
should now activate your rolling code equipped device. To
program additional HomeLink
威
buttons begin with step 2 in the
“Programming” section. For questions or comments, please contact
HomeLink at
www.homelink.com
or
1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink
威
to accept the signal
from the hand-held transmitter.
After completing steps 1 and 2
outlined in the
“Programming”
section, replace step 3 with the
following:
Note:
If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
•
Continue to press and hold the HomeLink
威
button (note step 3 in the
“Programming” section) while you press and release —
every two
seconds
(“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink
威
. The red indicator light
will flash slowly and then rapidly after HomeLink
威
accepts the radio
frequency signal.
•
Proceed with step 4 in the “Programming” section.
2004 Mountaineer
(mnt)
Owners Guide (post-2002-fmt)
USA English
(fus)
Driver Controls
59
Summary of Contents for 2004 Mountaineer
Page 280: ...280 ...
