Section 2 - Getting to Know Your Power Package
90-8M0074352
eng
OCTOBER 2012
Page 27
Panel Mount Features
a -
Lanyard stop switch
b -
Control handle
c -
Shift lock
d -
Trim/tilt switch
e -
Throttle only button
f -
Start/stop button
g -
Detent tension adjustment screw
h -
Control handle friction adjustment screw
Lanyard stop switch
‑
Turns the ignition off whenever the operator (when attached to the lanyard) moves far enough away
from the operator's position to activate the switch. Refer to
Lanyard Stop Switch
for information on the use of this switch.
Control handle
‑
Operation of the shift and throttle are controlled by the movement of the control handle. Push the control
handle forward from neutral with a quick, firm motion to the first detent for forward gear. Continue pushing forward to increase
speed. Pull the control handle back from neutral with a quick, firm motion to the first detent for reverse gear and continue
pushing back to increase speed.
Shift lock
‑
Pressing the shift lock allows the engine to shift. The shift lock must always be pressed when moving the control
handle out of the neutral position.
Trim/tilt switch (if equipped)
‑
Refer to
Power Trim
.
Throttle only button
‑
Allows engine throttle advancement without shifting the engine. The throttle only button can be
depressed only when the remote control is in the neutral position, and should only be used to assist in starting or warming up
the engine.
Start/stop button
‑
Allows the boat operator to start or stop the engine without using the ignition key.
Detent tension adjustment screw
‑
This screw can be adjusted to increase or decrease the effort required to move the control
handle out of the detent positions (cover must be removed). Turning the screw clockwise will increase tension.
Control handle friction adjustment screw
‑
This screw can be adjusted to increase or decrease the tension on the control
handle (cover must be removed). This will help prevent unwanted motion of the handle in rough water. Turn the screw
clockwise to increase tension and counterclockwise to decrease tension.
Console Mount Features ‑ Single Engine
a -
Control handle
b -
Trim/tilt switch
c -
Active light
d -
Neutral light
e -
Select key
f -
Arrow trackpad
g -
Throttle only/station select key
h -
Detent tension adjustment
i -
Control handle friction
adjustment screw
Control handle
‑
Operation of the shift and throttle are controlled by the movement of the control handle. Push the control
handle forward from neutral with a quick, firm motion to the first detent for forward gear. Continue pushing forward to increase
speed. Pull the control handle back from neutral with a quick, firm motion to the first detent for reverse gear and continue
pushing back to increase speed.
Trim/tilt switch (if equipped)
‑
Refer to
Power Trim
.
Active light
‑
The active light is illuminated to show the remote control is active and ready for use.
Neutral light
‑
The neutral light is illuminated when the engine is in neutral gear position.
NOTE: Gear position is determined by sensing the position of the shift actuator on the engine, not the position of the gear
switch.
Select key
‑
Selects System View on‑screen options and confirms data entries.
Arrow trackpad
‑
Navigates through System View on‑screen function messages.
3409
+
-
a
b
c
d
h
e
f
g
+
-
3410
a
b
c
d
e
f
g
i
h
