- 25 -
11 Typical Audio Connections between Sphynx & Mykerinos
This section will show some typical audio connection scenarios for the Sphynx Audio Interface and the Mykerinos board.
11.1 Audio for Video with SONY® Digital BetaCam Users
This example is based on Video NLE & DAW users who are using the Mykerinos board in conjunction with the Sphynx
Audio Interface and a Digital BetaCam video deck.
V
IDEO
&
D
IGITAL
A
UDIO
W
ORKSTATION
This example shows the following connections:
•
Monitoring can be done through the Digital BetaCam analog outputs, the Sphynx headphones output, the Sphynx analog
outputs (if analog output modules are installed) or the stereo monitoring connector of the Mykerinos board.
•
The Sphynx contains at least 2 AES-EBU input modules (4 mono inputs) and 2 AES-EBU output modules (4 mono
outputs). Analog output modules are optional in this configuration.
•
All units (The Mykerinos board via the TC card or breakout cable CVS1IN input, Video Deck and Sphynx) are
connected to the video reference generator.
Note that any composite video source can also be used as a video reference for Sphynx.
•
Note that the video loop output can be used to supply the video reference to other devices.
Otherwise, a 75-Ohms terminator must be connected to the Loop output.
•
The Sphynx is set to VIDEO or AES-EBU Sync Mode.