- 27 -
Picture 11
1.
Twist off one end of Route Low Row Cable (#86) (5250mml), route the cable through while
fixing the pulleys (#73) as shown. Then hang Ab Strap (#79) on the upper end of this cable
(#86) by using a Hoist Hook (#65)
2.
Attach Foot Plate (#31) to the Front Base Frame (#2) by using Round Tube (#32), end with
two
Φ
30 Hole Plugs (#115) at two sides respectively. Then connect the Low Row Bar (#33)
to the end of this cable (#86) by using two hoist hooks (#65) and a chain (#64).
3.
Slide two Foam Roller Tubes (#63) (440mml) respectively through the Leg Extension Arm
(#30) and Leg Extension Frame (#26), followed by sliding four Foam Rollers (#84)
respectively through each side of these Foam Roller Tubes (#63), end with plugging four
Foam Caps (#76).
•
Friendly Reminder:
Please check whether the cable is tight enough or not. If it is slightly
loose, it could be adjusted by changing the screw-in length at the end head of Lat Pulldown
Cable (#85, 3790mml). If it is very loose, it could also be adjusted by changing the hole on
the Adjustable Joint Plate (#49) where pulley is fixed.
Summary of Contents for FIT-AOXIN-M7S-ABCD2E
