Configuring the digital surround processor without a computer
65
To select a Type
●
Put the digital surround processor into standby by pressing
Off
(front panel or remote).
●
Hold down the
A
key on the front
panel until the display shows:
Type in... 3
●
Hold down the
A
key for three
more seconds until the display shows:
Type,wait...
It will then show the current Type
setting; for example:
Type 5.1 AAA
●
Press
▲
or
▼
on the front panel to select the Type.
For example, if you have two analogue
speakers select the display:
Type 2.0 A__
●
Wait for a few seconds, while the
display shows:
Typing, wait
●
Press the
Off
key on the front panel.
The display shows:
Exiting Type
To set up the 568 for use with a 562
or 562V Multimedia Controller
Select 562 Mode as follows:
●
Press the
Source
key on the front
panel; the display shows:
562 Mode on
●
Press the
Source
key again to turn off 562 Mode. While 562
Mode is on the Dolby indicator is illuminated.
In 562 Mode all the digital and analogue sources use CD/D1 and
TV/A1 respectively:
Source
Input
CD, Tape 2, CDR, Cable, DVD, and LD
CD/D1
Radio, LP, TV, Tape 1, VCR 1, and VCR 2
TV/A1
For information about connecting up the 568 see
To connect to
a 562 or 562V Digital Control Unit
, page 61.
Summary of Contents for Meridian 568
