92
Configuring the digital surround processor using a computer
●
If you have two Meridian source units of the same type you
can configure them to have different Comms addresses. You
can then select the appropriate source by specifying its
Comms address in the
Comms address
field.
The following additional options are available. You should only
change these with advice from your dealer:
Option
Description
30ms delay for audio
Avoids the noise caused by
sources to avoid DTS noise
switching to a DTS audio
(DTS delay)
source.
Only ever play DTS for this
Creates a video DTS source
source
that will avoid any DTS noise
when switching audio formats.
Number of frames of delay
Adds a delay required by
to apply to audio
certain video systems.
Poor digital audio source –
Select this if you have difficulty
frequency out of range
locking to the source.
Source uses validity flag
May reduce switching noise
properly
on certain sources where this
is a problem.
To set the advanced source options
●
Click the
Advanced
tab to show the
Advanced
page of
settings.
●
If the source is connected to another Meridian unit, set
Comms type
to
1C
for a Meridian CD player,
2C
for a
Meridian FM tuner, and
3C
for a Meridian DVD player.
Otherwise set it to
none
.
Summary of Contents for Meridian 568
