ASSEMBLY STEP 2
For Sectional and One-Piece Doors Only
Install the Trolley
•
Attach the trolley threaded shaft to the trolley with the
lock washer and nuts as shown.
•
As a temporary stop, insert a screwdriver into the hole
in the front end of the T-rail.
•
Slide the trolley assembly along the rail to the
screwdriver stop.
NOTE:
If trolley hits against any nuts on the
T-rail, the bolts and nuts were attached from
the wrong side and must be repositioned.
Review Assembly Step 1.
Trolley
Threaded
Shaft
L
ock Washer
5/16
"
Outer Nut
5/16
"
-18
Inner Nut
5/16
"
-18
Trolley
Trolley
Temporary Stop
Screwdriver
Lock Washer
5/16"
Nut
5/16"-18
HARDWARE SHOWN ACTUAL SIZE
ASSEMBLY STEP 2
For Sliding and Swinging Gates Only
Install the Trolley
•
Attach the trolley threaded shaft to the trolley with the
lock washer and nuts as shown.
•
Insert a hex bolt into the hole in the front end of the
T-rail.
•
Slide the trolley assembly along the rail until it rests
against the hex bolt
(
trolley stop
)
.
NOTE:
If trolley hits against any nuts on the T-rail,
the bolts and nuts were attached from the wrong
side and must be repositioned. Review
Assembly Step 1.
Trolley
Threaded
Shaft
L
ock Washer
5/16
"
Outer Nut
5/16
"
-18
Inner Nut
5/16
"
-18
Trolley
Hex
B
olt
Trolley Stop
Hex
B
olt
5/16
"
-18x7/8
"
Nut
5/16
"
-18
L
ock Washer
5/16
"
Cable Pulley
B
racket
Nut
5/16"-18
Lockwasher
5/16"
Hex Bolt
5/16"-18x7/8"
HARDWARE SHOWN ACTUAL SIZE
11
