ASSEMBLY STEP 4
For Sectional and One-Piece Doors Only
Install the Chain/Cable
1. Pull the cable loop from the
carton and fasten it to the
trolley with a master link
from the hardware bag
(
Figure 1
)
.
• Push pins of master link
bar through cable loop and
hole in front end of trolley.
• Push master link cap over
pins and past pin notches.
• Slide clip-on spring over cap and onto pin notches
until both pins are securely locked in place.
2. With the trolley against the screwdriver, dispense the
cable around the pulley.
3. Continue along the rail and around the motor unit
sprocket
(
Figure 2
)
. Proceed back around the correct
groove in the chain spreader
(
Figure 3
)
. The sprocket
teeth must engage the chain.
4. Use the second master link to connect the chain to
the flat end of the shaft
(
Figure 1
)
.
Check to make
sure the chain is not twisted.
5. Remove the screwdriver.
13
To avoid possible SERIOUS INJURY to fingers from moving
garage door opener:
• ALWAYS keep hand clear of sprocket while operating opener.
• Securely attach sprocket cover BEFORE operating.
Motor Unit
Sprocket
Install Chain
In This Direction
Chain
Spreader
Figure 2
Cable
Pulley
Cable
Loop
Master
Link Bar
Master Link
Clip-On Spring
Pin
Pin
Notch
Chain
Flat end
of Trolley
Threaded
Shaft
Master Link Cap
Master
Link Cap
Master Link
Clip-On Spring
Install Chain & Cable
In This Direction
Figure 1
Leave Chain
& Cable
Inside Carton to
Prevent Kinking
Keep Chain
Taut When Dispensing
6-Tooth
Sprocket
Opener
Mounting Plate
Chain
Spreader
8-Tooth
Sprocket
Opener
Mounting Plate
Chain
Spreader
Figure 3
One-Piece Doors
6- Tooth Sprocket Application
Sectional Doors
8-Tooth Sprocket Application
(
6-tooth sprocket can be used if slower travel speed is
desired.
)
