COPYRIGHT © 2005 MERIT INDUSTRIES, INC.
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Major Assemblies -
Blue MAXX/MAXX Classic Countertop (cont’d)
Troubleshooting Information - Removal/Installation of Major Assemblies -
Blue MAXX/MAXX Classic Countertop
Megatouch MAXX Technical Reference Manual
3. Connect the monitor signal cable to the motherboard.
4. Reconnect the monitor power connector to the monitor board.
5. Reconnect the touchscreen cable in the back of the controller, then reconnect the Molex
connector to the main harness.
6. After replacing the front bezel, install the hood on the chassis, connecting the fan power
connector, monitor control board, ground strap, and plastic drain tube. Then pull the lid towards
you until the spring-loaded levers lock into place. See Figures 1 and 2.
7. Close and lock the lid.
8. Replace and lock the coin box or coin box/bill acceptor assembly.
9. Plug in and turn on the game.
Hard Drive Removal
1. Turn off and unplug the game.
2. Unlock and open the lid.
3. Remove the screw securing the hard drive mounting plate to the game chassis.
NOTE: If your game was converted with an XL to MAXX Kit, the hard drive mounting plate will
be fastened with 2 hexnuts on either side of the edge of the mounting plate.
4. Remove the 4 screws and shoulder washers fastening the hard drive to the mounting plate and
remove the hard drive. See Figure 4.
5. Disconnect the 4-PIN power connector and hard drive ribbon cable from the hard drive, then
remove the hard drive from the game.
Hard Drive Installation
1. Connect the power connector and ribbon cable to the new hard drive.
2. Fasten the hard drive to the mounting plate with the 4 screws and shoulder washers. See
Figure 4.
3. Replace the hard drive and mounting plate in the game and secure it with the existing hard-
ware.
4. Close and lock the lid.
5. Plug in and turn on the game.
Touchscreen Removal
1. Turn off and unplug the game.
2. Unlock and remove the coin box or coin box/bill acceptor assembly.
3. Unlock and remove the lid by first disconnecting the fan power connector, then the clear drain-
age tubing (from lid end) and ground strap. Also remove the monitor control board attached
with velcro to the inside of the game. Then press up on the spring-loaded levers (located on
each side of the lid), push the levers forward, and lift and remove the lid. Also remove the front
bezel. See Figures 1 and 2.
