COPYRIGHT © 2006 MERIT INDUSTRIES, INC.
Section 5: Perimeter Lighting Controller
PM0599-03 MOD BOX INSTALLATION & OWNER’S MANUAL 40
If your MoD BoX includes the optional perimeter lighting on the door, there are operational
adjustments and pattern options that can be used. This section describes the available
options and explains how to program these options using the Lighting Controller that is
mounted on the back of the monitor (see Figure 5.1).
There are two push button switches on the LED Controller. One switch controls the
“PATTERN”, and the other switch controls the “BRIGHTNESS “.
The “PATTERN” option has 5 different settings. Push and release the “PATTERN” push button
to move between the settings. The settings are:
#1. BRIGHTNESS CONTROL (Light is on and remains at a constant level)
#2. FLASHES ON AND OFF AT THE PRESET BRIGHTNESS (See below)
#3. FLASHES ON AND OFF AT FULL BRIGHTNESS
#4. REPEATING FADE IN AND OUT AT: PRESET... OFF... PRESET BRIGHTNESS (See
below)
#5. REPEATING FADE IN AND OUT AT: FULL... OFF... FULL BRIGHTNESS
Pushing the “PATTERN” push button again repeats the sequence from #1.
The BRIGHTNESS option presets the brightness at a level lower than the maximum brightness
possible. If your jukebox is in a location where full brightness is too high, preset the brightness
to a lower level and choose either PATTERN #1, #2 or #4.
To change the preset maximum brightness, proceed as follows:
Push and release the “PATTERN” push button until the light is steady (not fading or
blinking). This is PATTERN #1. Next, press and hold the “BRIGHTNESS” push button: the
light output will either increase or decrease toward the maximum or minimum level. Hold
the push button until the brightness level is at either maximum or minimum - then release
it. Press and hold the “BRIGHTNESS” push button after reaching either endpoint to change
the brightness in the opposite direction. Regardless of which direction the brightness
is changing, when the desired maximum brightness is reached, release the push button
and that level will be used as the PRESET brightness.
Now use the PATTERN push button to choose the desired operating PATTERN.
You may leave the PATTERN at the #1 setting for a steady light level.
