Copyright Meritor, Inc., 2021
MM-96147 / Revised 03-21
Page 20
(16579)
Printed in USA
5 RPL Series Permalube
4. Pull the slip yoke and slip shaft sections apart. Figure 5.7.
Fig. 5.7
5. Remove the seal and shroud from the slip shaft. Figure 5.8
and Figure 5.9.
4001823c
SEAL
Fig. 5.8
4001824a
SHROUD
Fig. 5.9
Assembly
Standard Slip Confi guration
1. Remove the grease fi ttings from the slip yoke before you
assemble the slip yoke and spline shaft sections.
2. Use the grease packet supplied with the slip yoke to apply the
entire amount of grease into the slip yoke. Figure 5.10.
4003525a
Fig. 5.10
3. Use a brush to distribute lubricant on the splines. Figure 5.11.
4003524a
Fig. 5.11
4. Intall the new shroud onto the spline shaft. Figure 5.12.
4001824a
SHROUD
Fig. 5.12
