S742
Operating your Scooter
20
The brake release lever is situated at the right rear of the scooter. This lever
allows you to disengage the drive mechanism and push the scooter in
‘freewheel’ mode. To disengage the drive, pull the lever upward to the
‘disengaged’ position. The scooter can now be pushed.
Simply push the lever back down to re-engage the drive mechanism (the scooter
can now be driven). The scooter will not operate when the lever is in the
disengaged position. The scooter must be turned off and on by the key switch to
reset the circuits before it will resume normal operation. The status led will flash
continually if the brake is disengaged when it is switched on.
Brake Release / Freewheel Operation
Caution! Never leave the scooter unattended whilst in freewheel mode as it
will roll away down an incline. ‘Freewheel’ mode should only be used in an
emergency to move the scooter due to power failure. NEVER move the
scooter in this mode whilst it is occupied.
When in freewheel mode the scooter may be pushed on level ground at a
walking pace. The scooter will ‘auto-brake’ if this speed is exceeded.
Freewheel
Disengaged
Engaged
Dr
ive
Freewheel Mode
Summary of Contents for S742
