5
Mount the Stab
Trim open the stab opening.
Adjust the stab in position until you are satisfied that it is square. Using a felt tip pen, mark the underside
of the stab along the edges where it meets the fuselage. Slip it back out and trim out the covering on both
sides where the fuselage covers the stab
Mount the wings at this time and slide the stab back in place. Check that it is parallel with the wings. If
you find that it is not, slip the stab out and gently sand the fuselage away to bring the stab into parallel.
Work slowly and do not take much material at once. When you are satisfied with the alignment, make sure
the elevator is installed, and use a thin coat of 30 Minute Epoxy to glue the stab in the fuselage. Wipe up
any excess adhesive and set the fuse aside.
Build the Motor Mount
Using the included plywood pieces you will build a frame to hold the motor onto the front of your model.
Be sure that your kit includes all of the pieces shown below.
Using the two side frames and the round plate, lock them together as shown below.
