15
NOTE: The transmitter(s) supplied with your opener are
preprogrammed by the factory.
If you purchase additional transmitters, the garage door opener must
be programmed to accept the new remote code.
Program the Receiver to Match Additional Transmitter Codes:
Using the “S” SAVE Button
1.Press and Hold the button on the hand-held remote or wall button that
you wish to use (1).
2.Press and release the “S” button on the opener (2).
3.Release the remote button when the opener light flashes. It has learnt
the code. If you release the remote control push button before the
opener light flashes, the opener has not learned the code.
Now the opener will operate when the remote control push button is
pressed.
To Erase all Remote Control Codes
1.Press and Hold the “S” button on the opener until the indicator LED
goes ON, and continue holding for approx. 8 seconds, until the
indicator LED goes out.
2.Release the button, all codes are now erased.
Wireless Keypad E840M
To set the keyless entry PIN:
1.Locate the “S” button on the garage door opener.
2.Press and release the “S” button. The LED 1 indicator light will glow
steadily.
3.Enter a 4-digit personal identification number (PIN) of your choice
on the keypad.
4.Press and hold the ENTER button. Check to see if the opener light
flashes. Release the ENTER button after the light flashes.
To change an existing keyless entry PIN:
1.Enter the existing programmed PIN that you want to change.
2.Press and hold the # button until the courtesy light flashes once.
3.Enter the new 4-digit PIN of your choice, then press the ENTER
button. The light will flash once.
4.To test, enter the new PIN, then press the ENTER button. The
garage door opener will activate.
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should
enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s).
Do not allow children to play near the door.
1
2
S
P
1
2
3
1
2
3 2
2
2
3
4
3
Press and release
the “S” button
Enter a 4-digit
PIN of your
choice
? ? ? ?
_ _ _ _
Press and hold
the enter button
Opener light flashes
After the lights
flash release the
ENTER button
1
Locate the
“S” button
S
P
1
2
3
1
2
3 2
S
P
1
2
3
1
2
3 2
24
WIRELESS PROGRAMMING (OPTIONAL ACCESSORIES)
