Merlin G715D, Instructions For Installation And Use Manual

19

learn wireless control button (P2/RADIO)

Press  and  hold  P2/RADIO,  until  the  red  LED  is  lit,  to  begin  learning  wireless  remote 
controls. The red LED will be lit. Press a button for 3 seconds on each wireless control to 
be learned. Either wait 10 seconds, or press P2/RADIO again to exit learning. If the CH-
RADIO jumper is fitted, the wireless controls will operate the pedestrian Access mode; if it 
is removed then they will operate the gate normally.
To enter the Professional Setup routine press P2/RADIO within 5 seconds of pressing 
RESET, or applying power to the board, or while the yellow LED is flashing. 

learn wireless pedestrian access jumper (CH-RADIO) 

Place this jumper over the pins when you want to learn wireless remotes for Pedestrian 
Access mode.

force/speed/voltage setting trimmer (+ FOR -)

NOTE

  Press P1/SET after adjusting the trimmer.

The energy transferred to an obstruction is determined by the motor power, and the time 
that the power is applied to the obstruction. Motor power is determined by the maximum 
voltage and maximum current. This FOR setting alters the motor voltage. The Application 
Mode (page 7) alters the maximum allowable motor current. The OBS setting alters the 
time that power is applied to an obstruction. So safety is determined by a combination of 
the settings for FOR, OBS, and Application Mode.
Turn FOR clockwise to increase the voltage that is applied to the motors.
•  

Full clockwise: maximum voltage (less sensitive)

•  

Full anti-clockwise: min. voltage, approx. 50% of the maximum (more sensitive)

NOTE

  Voltage affects the speed of the motor. After any adjustment to FOR, either the 

Easy Setup or the Professional Setup procedure must be completed to set the operating 
time correctly.

auto-close pause setting trimmer (+ PAU -)

NOTE

  Press P1/SET after adjusting the trimmer.

WARNING

 Photocell sensor beams must be fitted when using auto-close.

This trimmer determines the length of time that the gate pauses before auto-closing.
•  

Full clockwise: auto-closing is disabled (that is, there is an unlimited pause when 
open)

•  

Full anti-clockwise: pause open for 15 seconds, then auto-close (unless a photocell 
is fitted)

•  

Other positions: adjust for pause times of between 3 seconds and 60 seconds

NOTE 

 In  auto-closing  mode,  any  command  to  open  or  close  will  cause  the  following 

behaviour:
•  

while opening, commands are ignored;

•  

while closing, commands will cause the gate to start to open;

•  

while paused open, commands will not close or open, but will restart the pause 
timer