G815
D
May 05
10
Typical installations: in-swinging gates
Typical installation: out-swinging gate
IMPORTANT
For all installations the angle between the drive arm and the gate should
always be convergent. If at any position the arm and gate are divergent, there will be
excessive stress placed on the gate components.
150
90
º
10
0º
11
0º
160
180
130
160
190
155
165
converging
diverging
diverging
diverging
converging
converging
converging
arm and gate converge at
one position, but diverge
at another, so installation
angles are not acceptable
arm and gate converging at
all positions so installation
angles are acceptable
arm and gate converge at
one position, but diverge at
others so installation angles
are not acceptable
converging
converging
diverging
diverging
WRONG!
RIGHT
WRONG!