25
CCOONNTTRROOLL IINNPPUUTTSS
Refer to Wiring Diagram on page 24.
WIRE STOP BUTTON (OPTIONAL)
A jumper wire is factory installed between the stop and
common input.
Stop (N/C) - Stop only (does not reset alarm).
NOTE: Stop jumper is required for normal operation
(the Stop LED will be lit except when the control board
goes into Sleep Mode). Remove only if remotely
mounted Stop button is added.
OPEN
Opens only or reverses a closing gate.
SBC (SINGLE BUTTON CONTROL) INPUT
This input will command the gate to
OPEN / STOP / CLOSE / STOP in sequence.
RESET CONTROL INPUT
The control box has a factory installed internal reset button.
These terminals are intended for use with a single reset
button that is installed within a line of sight of the gate.
This input functions to reset the alarms. This input will
NOT stop the gate.
NOTE: All control inputs must be Normally Open (N.O.)
dry contact type.
C2
CONTROL
INPUTS
OPEN
SINGLE BUTTON
RESET
STOP
COM
COM
COM
COM
CO
M
M
CO
M
M
CONTROL
INPUTS
OPEN
SINGLE BUT
T ON
RESET
S T OP
POWER
CONTROL
INPUTS
OPEN
SINGLE BUTTON
RESET
STOP
COM
COM
COM
COM
CO
M
M
CO
M
M
CONTROL
INPUTS
OPEN
SINGLE BUT
T ON
RESET
S T OP
POWER
Summary of Contents for MGA600
