5
Step 3 Mounting the motor to the Wall Bracket.
Once the Wall Bracket has been mounted, the drive can be
fitted. The drives can be used left or right without conver-
sion.
Using the hardware provided fit the Base Plate onto the Wall
Bracket. Place the Spacer provided into place as illustrated,
then insert the bolts provide through the square hole in the
Walll Bracket.
Ensure the connection cable is correctly positioned, and the
bolts are fitted correctly. Hand tighten the nuts to secure the
motor in postion, then using the washers and nuts provided
to fasten the motor securely in place using 13mm spanner
(not provided).
ART-7
Standard Base
Plate
ART-6
For Narrow
Pillars
or
Spacer
Step 4 Connect Motor to Loom.
Connect the Connection Cable in the motor as illustrated (fig1).
Step 5 Manual Release.
The release lock for the casing is located under the rubber waterproof cover. Use the socket spanner supplied in the
hardware bag to lift the cover up. The release key located beneath the hood should be inserted into the side openings
and turned approx. 180 degrees until it cannot turn any further. The drive has now been released. To re-engage it, the
key should be turned back to its original position.
NOTE: Take care when unlatching the drive for manual operation. The gate panel can move in an uncontrolled
way, especially if it is mounted in a sloped position.
fig 1
Summary of Contents for MGA600
