11
INSTALLATION
1. Using the fixed post bracket as a reference, mark and drill the holes for the post bracket.
2. Attach the post bracket to the post using appropriate fixings. Masonry fixings are supplied, if required. The correct fastening
material must be used based on existing installation (building / material substance). Please consult the gate manufacturer.
3. The slots on the post bracket allow for alignment. When the post bracket is level (see figure 1), tighten the nuts.
4. Attach the live post bracket to the fixed post bracket as per figure 2.
Level
M10x30 Screw
Non-slip nut
Drill hole
Washers
Nut
figure 1
1. Bring gate to the "closed“ position.
2. Attach the opener to the assembled post bracket using the clevis pin and secure with a hairpin clip (figure 1).
3. Assemble the assembled gate mounting bracket onto the arm using the fasteners & washers provided (figure 2).
4. Release the opener manual release with the release key. See section 11.
5. Position the gate mounting bracket as shown (figure 3).
6. Temporarily secure the gate bracket to the gate with a clamp.
7. Manually open and close the gate to the required positions. Ensure the opener does not bind. If the opening and closing positions
are OK, proceed to Step 8. If there is an issue with the desired opening position, change the gate bracket position or check if the
A and B dimensions of the post bracket were chosen correctly.
NOTE: Be sure that during the manual movement from close to open and vice versa, there is no obstruction or impact of
the arm against the leaf or pillar.
8. Close the gate and re-engage the release mechanism.
9. Connect the gate bracket securely to the gate in the chosen position with appropriate fasteners (not provided).
1115 mm
Spirit level
43.5 mm
730 mm with hardstops
750 mm w/o hardstops
Spirit level
1115 mm
Spirit level
43.5 mm
730 mm with hardstops
750 mm w/o hardstops
Spirit level
1115 mm
Spirit level
43.5 mm
730 mm with hardstops
750 mm w/o hardstops
Spirit level
figure 1
figure 3
figure 2
GATE BRACKET INSTALLATION
9
POST BRACKET INSTALLATION
8
Level
M10x30 Screw
Non-slip nut
Drill hole
Washers
Nut
figure 2
Summary of Contents for MGLDK
Page 43: ...43 NOTES...
