MERLO PANORAMIC User And Maintenance Manual Download

Page: 170 / 200

8 - ATTACHMENTS AND OPTIONAL EXTRA

8 - 19

VARIANTS AND ACCESSORIES

This chapter describes all the available accessories for this vehicle, based on the Merlo official price list.

WARNING! Use Merlo S.p.A. approved accessories only, type-approved for use on your vehicle.

Before using any accessory mentioned in the present chapter, it is necessary to read and fully understand the instructions on
its operation. If the installation or operation of the accessory is not entirely clear, please contact your dealership or Merlo
Technical Support Service.

WARNING! It is forbidden to use an accessory without reading and understanding its installation and

operation instructions.

Should more than one accessory be installed on the machine, the relative controls may be in a position that differ
from that indicated in the manual supplied with the machine. In any event please refer to the symbol that appears next
to the command itself, so that even if it should be in a different position it can be identified by the relative symbol
which is described in the manual.

GENERAL INSTRUCTIONS FOR THE USE OF THE MACHINE APPROVED AS ITALIAN OPERATIVE

NOTE!

The items in annex II of the Directive 2009/144/CE, as amended by the Directive 2010/52/CE, point 4.1 to the letter
d,f,p,q, point 4.2 to the letter b,d,e,g,k and the points 4.5.1.3, 4.5.2, 4.5.3 do not apply.

• POSITIONING POINTS FOR THE HYDRAULIC JACKS APPLICATION

If the machine has to be lifted in order to replace a tyre, the hydraulic jacks can be applied at the points indicated below:

A) front jacking point: place the hydraulic jack in correspondence to the central part of the machine's front axle, as indicated by
the arrow
B) rear jacking point: place the hydraulic handler in the central-rear part of the machine, as indicated by the arrow

Refer  to  "DETERMINATION  TABLE  OF  THE  TOTAL  MASS,  THE  LOADS  PER  AXLE  AND  THE  LOAD  CAPACITY  OF  THE
TYRES" in this chapter to select the hydraulic jack type to suit Your needs.

•  GENERAL  INDICATIONS  ON  THE  USE  OF  ATTACHMENT  OR  TRAILERS
CONNECTED TO THE MACHINE

Before  using  Your  machine  with  a  towed  attachment  or  fitted  on  a  trailer,
carefully  observe  the  instructions  shown  in  the  use and maintenance manual of
the machine and in the manual of the attachment or trailer connected. Otherwise
do not use the above indicated combinations.

WARNING!

It is forbidden to linger in the area between the machine and the vehicle or
the attachment being towed.

•  DETERMINATION  TABLE  OF  THE  TOTAL  PERMITTED  MASS,  THE  LOADS
PER AXLE AND THE LOAD CAPACITY OF THE TYRES

Refer to following table for information on the total permitted masses on the front
and rear axle and the maximum applicable load on the tyres of Your machine.

This  information  is  also  useful  for  the  determination  of  the  hydraulic  jack  to  be
used  for  the  tyre  replacement  operations.  (see  paragraph  "POSITIONING
POINTS FOR THE HYDRAULIC JACK APPLICATION" of this chapter).