15
Step 25
Adjusting fixed and hinged panels.
If after fitting doors and fixed panel and you still need adjustment to align doors
etc, you can achieve this by loosening the screws fixing the plate/hinge to the wall
and the bolts clamping the hinge to the glass.
Adjust the panels until the desired fit is achieved. Fully tighten all fixings.
Note: If not further adjustment is needed make sure all fixings have been tightened
securely.
INSIDE
Drill with 6mm masonary
drill bit.
MG6x30PLUG
Level the rail.
Mark the centre of the
slot.
Step 26
Fix the top rails.
26A
Step 27
Door adjustment
To adjust door to get required contact against closing seal first support door
with door locating aids. Loosen all bolts fixing both hinges to glass and move by
required amount. Tighten all bolts and remove door positioning aids.
Where an angled bracing bar is fitted additional adjustment can be made by:
1) Loosen the 3 screws clamping the glass.
2) Move the glass panel in the direction required(see arrow).
3) Tighten the 3 screws.
Additional adjustment
Step 28
INSIDE
INSIDE
28A
①
②
③
Fitting cover caps.
Step 29
Peel off protective strip to adhesive tape to back of cap and firmly press in
position.
Tip
:
We recommend that you place a dab of silicone to the back of the cover caps
at each end of the tape.
Fix the wall bracket.
fit wall bracket
caps
INSIDE
INSIDE
26B
26C
26D
26E
28B
16
