Installation of Car Bed in Vehicle, Cont.
INSTALLATION
Page 36
Steps 1– 5 demonstrate a lap only belt installation.
1. Grasp the lap belt located closest to the vehicle door and pull it down
through the belt slot (nearest the foot end of the car bed—Figure A) to its
mating buckle (Figure B).
B
2. Attach the lap belt to the buckle
(Figure B).
A
Attaching Cummerbund and Restraint Bag, Cont.
Page 17
ASSEMBLY
Restraint Bag Installation, Cont.
4. Repeat Steps 2 and 3 for the left
side of the restraint bag (Whose
metal anchors are shown in Fig.
F). It is necessary to compress
bottom cushion to insert metal
anchors on the left side of re-
straint bag. Lock anchors in
place from the bottom of the
car bed.
5. Replace the 1/2” and 1 ½” side
EPS panel (Figure G).
6. Push each of the restraint bag
shoulder straps through the
bottom slots in the bottom
cushion (Fig. I) and then
through mating slots (second
from bottom) in plastic shell
(Fig. J).
7. Continue to pull straps through
the bottom of the shell (Fig J).
J
F
Bottom Slots (Cushion)
Bottom of Plastic Shell
NOTE:
Verify that the 1 1/2” (thicker)
EPS pad is positioned on side of
car bed next to the label in
Figure H—See arrow).
I
G
H
