background image

                                                                                 

Dust

 

Collector

 

System

 

 

Owner

 

Manual

 

 
 
 
 
 
 
 

7   MAINTENANCE INSTRUCTION 
 
 
 
NOTE: A loose or unsecured bag will allow product to pass through the filter separator and will 
plug the in-line filter.  

 
The filter bags should be shaken at least daily, preferably after each use. To shake filter bags, simply 
open the bag house door and shake the filter assembly arm swiftly back and forth. This rapid movement 
will dislodge particles on the inside of the filter bag surfaces and drop them into the dust can.  
 

NOTE: The unit must be OFF in order to shake the filters.  

 

NOTE : If the filters are to be replaced, please replace them ALL at once, or they will be a constant 
source of frustration.  

 

Filter Bag Maintenance  

 
The following is a recommended program of preventative maintenance:  

1.  Check that the filters are seated properly and that they do not appear to be leaking WEEKLY. 

There should be NO appreciable or visible dust inside the service access door.  

2.  Replace ALL the filters if wear points or holes are noticed 
3.  If the secondary filter cartridge becomes plugged rapidly, check for holes in the primary filter 

bags, or upgrade the primary filter material to a more efficient type 

4.  Replace the secondary filter cartridge when the manometer reads higher than 12” WG 

 
 
 

Removing Filter Bags  

 
To change the filter bags, remove each bag from the filter shaker assembly inside the tank at the top.  
Squeeze the spring cuff at the bottom of the bag compressing the snap ring into a “U” shape, and remove 
from the bag plate hole. 
 

Installing New Filter Bags  

 
Attach the grommet in the bag with bolts on the filter shaker assembly inside the tank at the top.  
Grasp the spring cuff at the bottom of the bag and compress into a “U” shape. Insert into the proper hole 
in the bag plate, and release the bag bottom, assuring the “groove” in the bag cuff is centered in the bag 
plate hole.  
After installing all the filters, check the installation from below; all the filters should be neatly and evenly 
seated.  
 
 

WARNING: Failure to assure proper seating of the bag in the bag plate will allow material leakage.

 

 
 
 
 

Reviews: