53
Other display views
Stored key function
(key sequence see Figure
/
)
Time control channel 1
Time control channel 2
Other display views
Er...
This message is shown together with an error number when
an error occurs:
• after an initialisation
• after a power failure
• if, for example, the actual temperature is not correctly
recorded.
If such an error message appears, always contact your
electrician.
A 1 ... A 5
This message is shown during the initialisation phase (for
approx. 1 minute). No action is necessary.
Presettings table
Key 3: ____________________
Key 4: ____________________
Key 5: ____________________
Key 6: ____________________
Key 7: ____________________
Key 8: ____________________
Switching
time 1
Switching
time 2
Switching
time 3
Switching
time 4
___:___
___:___
___:___
___:___
Function:
____________________________________________
Switching
time 1
Switching
time 2
Switching
time 3
Switching
time 4
___:___
___:___
___:___
___:___
Function:
____________________________________________
54
Presettings table
Alarm functions
Setpoint values for heating
Setpoint values for cooling
Setpoint adjustment valid until:
Operation mode change / permanent
Week starts (1):
on Fri / Sat / Sun / Mon
Direct selection:
Setpoint temperature / operation mode / none
Alarm sounds if actual temperature is less than the frost
protection temperature or greater than the heat protection
temperature
Alarm sounds when the setpoint adjustment limit is exceeded
Other: ____________________________________________
Comfort: _____ °C
Adjustment limit min _____ °C, max _____ °C
Standby: _____ °C
Adjustment limit min _____ °C, max _____ °C
Night:
_____ °C
Adjustment limit min _____ °C, max _____ °C
Comfort: _____ °C
Adjustment limit min _____ °C, max _____ °C
Standby: _____ °C
Adjustment limit min _____ °C, max _____ °C
Night:
_____ °C
Adjustment limit min _____ °C, max _____ °C
Frost protection: ____
°C
Heat protection: ____ °C
