16
D.
Changing the Units of Measure
Units of measure may be changed for conductivity, temperature, and pressure by using
the following procedures. Once new units of measure have been selected, they will be
retained in the sensor module until changed again by the user.
Conductivity units:
Select the channel displaying
conductivity on the MAIN screen using
the arrow keys.
Make sure that conductivity is the
dominant parameter being displayed
and press MENU. Use the SWAP key to
change the dominant parameter if
necessary.
Select “UNITS OF MEASURE” from the
MENU screen.
Scroll to the units desired using the
arrow keys and press “SEL”. After a brief
pause, the display will return to the
MAIN screen and display the parameter
in the new units.
Temperature units
:
Select the channel displaying
temperature on the MAIN screen using
the arrow keys.
Make sure that temperature is the
dominant parameter being displayed (if
not press SWAP) and press MENU.
Select “UNITS OF MEASURE” from the
MENU screen.
Scroll to the units desired using the
arrow keys and press “SEL”. After a brief
pause, the display will return to the
MAIN screen and display the parameter
in the new units.