MeshLinx MWI-5000 User Guide
MESHLINX CONFIDENTIAL
1
4.2.3.7
Bootconfig
get bootconfig
– Display the boot configuration file for next
boot.
set bootconfig <cfg_filename>
- Select the configuration file
used to boot the MWI-5000 System. The change takes effect on
the next system boot.
4.2.3.8
Start
start [ap | eth | wif<1|2|3|*> | tcpip | dhcp | http |
autoconfig
| radius | snmp | dfs ]
4.2.3.9
Stop
stop [ap | eth | wif<1|2|3|*> | tcpip | dhcp | http |
autoconfig
| radius | snmp | dfs]
4.2.3.10
Reset
reset
- this command resets the AP system.
4.2.3.11
WIF (WLAN Interface)
get wif*
- Get all sectors status.
get wif<1|2|3> opmode
– Get operating mode of the wireless
interface
get wif<1|2|3> channel
- Get channel number and AICS.
get wif<1|2|3> maxrate
- Get sector max rate.
get wif<1|2|3> basicrate
– Get sector basic rate setting.
get wif<1|2|3> sensitivity
– get sector RX sensitivity.
get wif<1|2|3> rts
– Get RTS setting (enabled/disabled).
get wif<1|2|3> cts
– Get self-CTS setting (enabled/disabled)
get wif<1|2|3> frag
- Get frag
get wif<1|2|3> txpower
– Get Tx power and ATPC.
get wif<1|2|3> beacon
- Get beacon interval.
get wif<1|2|3> header
- Get header type.
get wif<1|2|3> mode
– displays operating mode 11G, 11A, 11BG
or 11B.
get wif<1|2|3> diversity
–
displays antenna diversity.
get wif<1|2|3> dpd
– displays Digital Pre-Distortion
configuration of sector baseband.
Set wif
X
sets the specified parameter for the sector number used for
X
, where
X
is
1-3. The selected parameter is set for all WIFs if wif* is used with this command.