MeshLinx MWI-5000 User Guide
MESHLINX CONFIDENTIAL
2
same as a standard AP.
Autoconfig
/
LnL
must be enabled by the user
for it to be operational. This is set as the default to simplify
certification testing.
set <
autoconfig
|
LnL
> <enable | disable> –
enable or disable the
Autoconfig
/
LnL
on the wireless access point. Enable
Autoconfig
/
LnL
is only the initial step before starting the
Autoconfig
/
LnL
.
LnL
is
still not running, it is only enabled. Note: if
Autoconfig
/
LnL
is
running, ‘stop <
autoconfig
|
LnL
>’ must be executed before ‘set
<
autoconfig
|
LnL
> off ‘ can be run. Otherwise, an error message will
be returned.
set <
autoconfig
|
LnL
> mode <sector|omni>
– set the operational mode
of
Autoconfig
/
LnL
on the wireless access point (sector –
Autoconfig
/
LnL
will be running in SDMA mode, omni –
Autoconfig
/
LnL
will be running in omni-directional access point mode).
set <
autoconfig
|
LnL
> superscan <enable | disable>
- enable or
disable super scanning mode when
Autoconfig
/
LnL
is started. Super
scanning mode will allow all the wireless interface scan all the
channel before selecting the best channel.
set <
autoconfig
|
LnL
> metric <1>
– configure channel selection
metric policy setting. 1) Sum RSSI-based.
set <
autoconfig
|
LnL
> config <1>
– configure channel configuration
policy setting. 1) Pre-defined sequence/rotation-based channel
configuration.
set <
autoconfig
|
LnL
> smooth <1|2>
– configure channel adaptation
smoothing algorism policysetting. 1) No channel adaptation with
any station associated. 2) No channel adaptation if number of
stations associated is greater than threshold.
set <
autoconfig
|
LnL
> sta_thresh <1:100>
– configure channel
adaptation smoothing algorism threshold.
set <
autoconfig
|
LnL
> feedback <1>
– configure dynamic transmit
power control feedback policy setting. 1) Transmit power control
closed-loop feedback.
set <
autoconfig
|
LnL
> coop <1|2>
– configure interference
mitigation policy setting. 1) Minimize interference with only L&L
capable APs 2) Minimize interference with all APs in vicinity.
set <
autoconfig
|
LnL
> sdma <1>
– configure channel scanning policy
setting in SDMA mode. 1) Initial full all-sector scan only.
set <
autoconfig
|
LnL
> roguemitigation <enable|disable>
Enables/Disables the rogue AP detection and mitigation feature.
get <
autoconfig
|
LnL
>
- get the summary of all the configuration of
Autoconfig
/
LnL
.
get <
autoconfig
|
LnL
> mode –
get the current mode of
Autoconfig
/
LnL
.
It is either ‘sector’ or ‘omni’ (sector –
Autoconfig
/
LnL
will be
