MeshLinx MWI-5000 User Guide
MESHLINX CONFIDENTIAL
2
running in SDMA mode, omni –
Autoconfig
/
LnL
will be running in
omni-directional access point mode).
get <
autoconfig
|
LnL
>
superscan
– get the super scanning mode
configuration of
Autoconfig
/
LnL
.
get <
autoconfig
|
LnL
> metric
– get the channel selection metric
policy setting.
get <
autoconfig
|
LnL
> config
– get the channel configuration policy
setting.
get <
autoconfig
|
LnL
> smooth
– get the channel adaptation smoothing
algorism policysetting.
get <
autoconfig
|
LnL
> sta_thresh
– get the channel adaptation
smoothing algorism threshold.
get <
autoconfig
|
LnL
> feedback
– get the dynamic transmit power
control feedback policy setting.
get <
autoconfig
|
LnL
> coop
– get the interference mitigation policy
setting.
get <
autoconfig
|
LnL
> sdma
– get the channel scanning policy setting
in SDMA mode.
get <
autoconfig
|
LnL
> roguemitigation
Returns the current status of the rogue detection and mitigation.
start <
autoconfig
|
LnL
>
- start
Autoconfig
/
LnL
on the access point.
Note: ‘set <
autoconfig
|
LnL
> on’ must be executed before this
command can be run, otherwise, an error message will be returned.
stop <
autoconfig
|
LnL
>
- stop
Autoconfig
/
LnL
on the access point.
Note
: When
Autoconfig
/
LnL
is running, the following wireless
command will return error messages. The reason is the system design
doesn’t allow user intervention in setting wireless RF parameters
when
Autoconfig
/
LnL
is running.
Examples
To start
Autoconfig
/
LnL
in SDMA mode from a default system
configuration
set
autoconfig
enable
set
autoconfig
mode sector
start
autoconfig
To start
Autoconfig
/
LnL
in OMNI mode from a default system
configuration with super scanning enabled
set
autoconfig
enable
set
autoconfig
mode omni
set
autoconfig
superscan enable