Mesko MS7804, User Manual

19. When using the heater, completely unwind its cable and make sure that the cable is not 
touching the hot surface of the heater.

22. The heater is filled with a set amount of special oil. Repairs requiring opening of the oil 
container must be carried out only by the manufacturer or authorized representative, who 
should be contacted if oil leaks from the heater.

sink filled with water.

18. Do not cover the heater with curtains, a towel or hang washing on it – this can damage 
the heater or cause a fire.

21. The device must be completely cool prior to storage. Keep the original packaging to 
store the heater in during non-heating seasons.

16. The power cable should not be placed above the heater, and also should not touch or 
lie close to hot surfaces. Do not place the heater under an electrical outlet.

WARNING: To avoid overheating do not cover the heater.

1. On/Off switch

23. If disposing of the heater please follow rules of oil disposal.

DESCRIPTION OF THE DEVICE (Fig. 1)

17. The surface of the heater can heat up to high temperatures of over 60 degrees C. Take 
care when near the heater.

2. Thermostat control knob

20. Do not use the heater near basins, showers, sinks, pools or other places where it can 
get wet.

15. The heater should be placed on a level, heat-resistant surface, away (at least one 
meter) from flammable materials (lace curtains, curtains, wallpaper, furniture etc.). 

3. Wipe the heater with a damp cloth, then wipe dry.

Power source: 220-240V~50/60 Hz

MS7805 –  1000 W

Ms7806 –  1200 W

CAUTION: During first use of the heater a small amount of smoke may appear. This is normal.

3. Turn the heater on by he switch (1). Set a comfortable oil heater temperature by turning the thermostat control knob.

1. Place the oil heater a minimum of 100 cm from walls, furniture, curtains, plants etc.

2. Prior to cleaning allow the heater to cool. Make sure that it is cool.

MS7804 –  700 W

4. Never use wax, shining agents or chemical agents to clean the heater. They may react with the device and cause discoloration or 

even damage.

4. After you finish using the heater, turn it off by turning the on-switch and thermostat control knob to 'OFF' and disconnect the power 

cable from mains power.

Power:

1. Prior to cleaning always remove the plug from the electrical outlet.

TECHNICAL DATA

3. Ribs

USING THE DEVICE

2. Connect the oil heater to mains power.

CLEANING THE DEVICE

6

Device is made in class I of insulation and has to be 

connected only to power outlet with ground circuit.

Device is compliant with EU directives:

 - Low voltage directive (LVD)

 - Electromagnetic compatibility (EMC)

Device marked CE mark on rating label

To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins. 

Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may effect the 

environment. Electrical appliance must be returned in order to reduce its reuse and utilization. If the device contains batteries 

they should be delivered to dedicated points separatelly.