Form 44201460
41
Mar 2019
REMOVAL OF IGNITION CONTROL MODULE AND TRANSFORMER
21.5)
1.
Open the access panel assembly as shown in Section 21.2) Note: This is removed from the illustration for
clarity. Disconnect the ignition cable from the ignition control module.
2.
Disconnect the 5 way Molex electrical wire harness connector (not shown) from the module. Remove the
screws 2 holding the ignition control module and remove it from the heater.
3.
Disconnect the transformer lead wires. Remove the screws 3 holding the transformer and remove it from
the heater.
REMOVAL OF MAIN BURNER/EMITTER ASSEMBLY
21.6)
A.
Remove the ceramic glass and open the access panel assembly as shown in Section 21.1)
B.
Remove the gas valve as shown in Section 21.4)
1.
Remove the burner access panel 2 from the opposite side of the heater.
2.
Remove the (2) locknuts 3 holding the main burner.
3.
Slide the burner slightly toward the front of the heater.
4.
Rotate the burner away from the heater.
5.
Slide the burner out from the heater. Replace the burner in reverse order.
Summary of Contents for 44625000
Page 37: ...Form 44201460 37 Mar 2019...
Page 45: ......
