3-5
Operating and Maintenance Manual
Safety Provisions
code 5040275001 Rev. September 2010
WARNING
The risk can be drastically reduced by wearing the Individual Protective
Gear listed in this chapter, considered indispensable. Always work with due
caution when near the dangerous areas indicated by the signs on board the equipment.
3.8 GENERAL
WARNINGS
ATTENTION
The equipment generates, uses and can radiate energy and radio frequencies.
If not installed and used in agreement with the indications given in this manual, it can inter-
fere with radio communications.
- The equipment must be kept and used in accordance with the instructions given herein and
as suggested from time to time.
- The department manager must instruct the operating and maintenance personnel on how to
use and service the equipment in complete safety.
- Only specialized and specifically instructed personnel must be allowed to access the equip-
ment for maintenance work.
All the time such maintenance work is being done,
‘Work underway’
signs must be affixed
in the department that can be seen from all access points.
- Connection of the equipment (and of any accessory devices) must include standard earthing
to discharge short circuit current and electrostatic voltages. Mains voltage must correspond
to the value on the ID plate. Use of current adapters is not allowed. When connecting pay
attention to polarities.
- Any work on the equipment must be done only after it has been disconnected from the supply
mains via the switch which must be padlocked.
- When the equipment is received, or prior to switching on each time, DO NOT switch the UPS
on if the batteries are leaking.
- Tools used for maintenance (pliers, screwdrivers, etc.) must be the electrically insulated
type.
- It is strictly forbidden to deposit combustible materials near the equipment. It must always
be kept locked and access allowed only to specifically trained personnel.
- Do not deactivate the safety devices or delude the indications, alarms and warnings, whether
they are communicated automatically or by means of plates on the installation.
- Do not turn the machine on without the fixed protections in place (panels, etc.).
Summary of Contents for ARCHIMOD 100
Page 2: ......
Page 69: ...12 1 Operating and Maintenance Manual Notes code 5040275001 Rev September 2010 12 Notes...
Page 70: ......
Page 71: ......