24
English
CAUTION
Always secure the workpiece with the right hand
side for compound cutting. Never rotate the table
to the right for compound cutting, because the
saw blade might then contact the clamp or vise
that secures the workpiece, and cause personal
injury or damage.
7. Crown molding cutting procedures
Fig. 27 shows two common crown molding types
having angles of (
θ
) 38° and 45°.
For the typical crown molding
fi
ttings, see Fig. 28.
Ceiling
Wall
Ⓐ
Upper surface of
crown molding
Crown molding
Ⓑ
Lower surface of
crown molding
Fig. 27
Wall
Outside corner
Ceiling
Inside corner
Crown molding
Fig. 28
The table below shows the miter angle and the bevel
angle settings that are ideal for the two crown molding
types.
NOTE
For convenience, positive stops are provided for the
miter setting (left and right 31.6°) positions.
For miter cut setting
If the turntable has been set to either of the angles
described, move the turntable adjusting side handle a
little to the right and left to stabilize the position and to
properly align the miter angle scale and the tip of the
indicator before the operation starts.
For bevel cut setting
Turn the clamp lever on bevel section to the left and
check that the position is stable and that the bevel
angle scale and the tip of the indicator are properly
aligned. Then tighten the clamp lever.
Type of Crown Molding
45° Type 38° Type
To process crown molding at
positions and in Fig. 28.
Miter Angle Setting
right
35.3°
( mark)
right
31.6°
( mark)
Bevel Angle Setting
left
30°
( mark)
left
33.9°
( mark)
To process crown molding at
positions and in Fig. 28.
Miter Angle Setting
left
35.3°
( mark)
left
31.6°
( mark)
Bevel Angle Setting
left
30°
( mark)
left
33.9°
( mark)
(1) Setting to cut crown moldings at positions and
in Fig. 28 (see Fig. 29; tilt the motor head to the
left):
Turn the turntable to the right and set the Miter Angle
as follows:
○
For 45° type crown moldings:
35.3° ( mark)
○
For 38° type crown moldings:
31.6° ( mark)
Tilt the motor head to the left and set the Bevel Angle
as follows:
○
For 45° type crown moldings:
30° ( mark)
○
For 38° type crown moldings:
33.9° ( mark)
Position the crown molding so that the upper surface
(
Ⓐ
in Fig. 27) contacts the fence as indicated in
Fig. 31.
00Book̲C1810DFA̲NA.indb 24
00Book̲C1810DFA̲NA.indb 24
2022/02/22 14:08:18
2022/02/22 14:08:18
