(3) If no abnormal operation is observed, you may load
staples and caps in the Stapler.
Drive staples into the workpiece that is the same type
to be used in the actual application.
□
THE STAPLER MUST OPERATE PROPERLY.
SINGLE SEQUENTIAL ACTUATION
MECHANISM
Identi
fi
ed by: RED TRIGGER
(1) Remove the
fi
nger from the trigger and press the
push lever against the workpiece.
□
THE STAPLER MUST NOT OPERATE.
Do not pull Trigger
Depress
Push Lever
(2) Separate the push lever from the workpiece.
Next, point the Stapler downward, pull the trigger and
then wait in that position for 5 seconds or longer.
□
THE STAPLER MUST NOT OPERATE.
Pull Trigger
(2) REMOVE ALL STAPLES AND CAPS FROM
STAPLER
Remove the hook if it is attached.
→
When the hook is attached, do not operate with
CONTACT ACTUATION MECHANISM.
DO NOT push or rest Push Lever against any surface.
DO NOT FORCE OR USE ANY TOOLS TO
OPERATE SWITCH.
(3) Adjust the air pressure to 70 psi (4.9 bar 5 kgf/cm
2
).
Connect the air hose.
Do not load any staples or caps in the Stapler.
□
THE NAILER MUST NOT LEAK AIR.
(4) Remove the
fi
nger from the trigger and press the
push lever against the workpiece.
□
THE NAILER MUST NOT OPERATE.
(5) Separate the push lever from the workpiece.
Next, point the Stapler downward, pull the trigger and
then wait in that position for 5 seconds or longer.
□
THE STAPLER MUST NOT OPERATE.
Pull Trigger
CONTACT ACTUATION MECHANISM
Identi
fi
ed by: BLACK TRIGGER
(1) With the Stapler o
ff
the workpiece, pull the Trigger.
Next, depress the Push Lever against the workpiece.
□
THE STAPLER MUST OPERATE.
(2) Next, depress the Push Lever against the workpiece.
Now pull the Trigger.
□
THE STAPLER MUST OPERATE.
14
English
000Book̲N3808AP̲NA̲metabo.indb 14
000Book̲N3808AP̲NA̲metabo.indb 14
2018/02/05 18:14:06
2018/02/05 18:14:06
