23
English
6. WARNING
LABEL
Do not use the Nailer with missing or damaged
WARNING LABEL.
A new WARNING LABEL is available from a
metabo HPT authorized service center.
Warning
Label
7. Maintenance chart (See page 23)
8. Operator troubleshooting (See page 24)
CAUTION
●
In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
SERVICE AND REPAIRS
WARNING
●
Only service personnel trained by
metabo HPT, distributor or employer
shall repair the Nailer.
●
Use only parts supplied or recommended by
metabo HPT for repair.
All quality Nailers will eventually require servicing or
replacement of parts because of wear from normal use.
NOTE:
Speci
fi
cations are subject to change without any
obligation on the part of metabo HPT.
Maintenance chart
ACTION
WHY
HOW
Drain air line
fi
lter daily.
Prevent accumulation of moisture
and dirt.
Open manual petcock.
Keep lubricator
fi
lled.
Keep the Nailer lubricated.
Fill with metabo HPT pneumatic tool
lubricant.
Clean
fi
lter element and blow air
through
fi
lter in direction opposite to
normal
fl
ow daily.
Prevent clogging of
fi
lter with dirt.
Follow manufacturer’s instructions.
Clean magazine and feeder
mechanism.
Prevent a jam.
Blow clean daily.
Keep push lever working properly.
Promote operator safety and e
ffi
cient
Nailer operation.
Blow clean daily.
Lubricate the Nailer after nailing.
Extend the Nailer life.
Supply 5–10 drops of lubricant into
the Nailer.
Drain air compressor daily.
Keep the Nailer operated properly.
Open petcock on air compressor
tank.
000Book̲NV83A5̲US̲metabo.indb 23
000Book̲NV83A5̲US̲metabo.indb 23
2022/05/19 11:02:40
2022/05/19 11:02:40
