ASSEMBLY AND OPERATION
REMOVAL AND INSTALLATION METHOD
OF BATTERY
○
How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 5).
○
How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery (Fig. 5).
Battery
Pull out
Handle
Latch
Push
Insert
Fig. 5
APPLICATIONS
○
Planing various wooden planks and panels
23/64"(Max)
(9mm)
Fig. 4-A (Planing)
Fig. 4-B (Beveling)
Fig. 4-C (Rabbeting)
23/64"(Max)
(9mm)
Side face cutting
Fig. 4-D (Tapering)
Fig. 4-E (Side planing of
fl
ush door)
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○
The power source voltage is stated on the
nameplate.
○
The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1. Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charger’s pilot
lamp will blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
10
English
000Book̲P18DSL.indb 10
000Book̲P18DSL.indb 10
2018/10/16 17:38:40
2018/10/16 17:38:40
Summary of Contents for P 18DSL
Page 65: ...65 000Book P18DSL indb 65 000Book P18DSL indb 65 2018 10 16 17 38 46 2018 10 16 17 38 46 ...
Page 66: ...66 000Book P18DSL indb 66 000Book P18DSL indb 66 2018 10 16 17 38 46 2018 10 16 17 38 46 ...
Page 67: ...67 000Book P18DSL indb 67 000Book P18DSL indb 67 2018 10 16 17 38 46 2018 10 16 17 38 46 ...
