(5) As shown in Fig. 23, 24, insert a turned portion of set
plate (A) attached to set plate (B) into a groove on the
fl
at portion of the cutter block.
Set plate (A)
Flat portion of the cutter block
Fig. 23
Groove
Fig. 24
(6) As shown in Fig. 25, place the blade holder on the
completed assembly and fasten it with the three bolts.
Ensure that the bolts are securely tightened. Follow
the same procedures for the opposite side carbide
blade.
Bolt
Blade holder
Fig. 25
CUTTER BLADE ASSEMBLY AND
DISASSEMBLY AND ADJUSTMENT OF
CUTTER BLADE HEIGHT
WARNING
●
To prevent accidents, ensure that the power tool
is switched o
ff
and pull out the battery.
●
Be careful not to injure your hands.
1. Cutter blade disassembly
(1) As shown in Fig. 26 use the accessory box wrench
to withdraw the three bolts used to retain the cutter
blade, and remove the cutter blade holder.
Box wrench
Blade holder
Fig. 26
(2) As shown in Fig. 27, slide the blade in the direction
indicated by the arrow to disassemble the blade.
Set plate (B)
Fig. 27
2. Cutter blade assembly
CAUTION
Prior to assembly, thoroughly wipe o
ff
all swarf
accumulated on the cutter blade.
(1) Insert a turned portion of set plate (A) attached to the
blade into a groove on the
fl
at portion of the cutter
block. (Fig. 28, 29)
Set the blade so that both sides of the blade protrude
from the width of the cutter block by about 3/64"
(1 mm) (Fig. 30)
Flat portion of the cutter block
Set plate (A)
Fig. 28
16
English
000Book̲P18DSL.indb 16
000Book̲P18DSL.indb 16
2018/10/16 17:38:41
2018/10/16 17:38:41
Summary of Contents for P 18DSL
Page 65: ...65 000Book P18DSL indb 65 000Book P18DSL indb 65 2018 10 16 17 38 46 2018 10 16 17 38 46 ...
Page 66: ...66 000Book P18DSL indb 66 000Book P18DSL indb 66 2018 10 16 17 38 46 2018 10 16 17 38 46 ...
Page 67: ...67 000Book P18DSL indb 67 000Book P18DSL indb 67 2018 10 16 17 38 46 2018 10 16 17 38 46 ...
