ASSEMBLY AND OPERATION
APPLICATIONS
○
Cleaning house etc.
○
Blowing
operation.
REMOVAL AND INSTALLATION
METHOD OF BATTERY
○
How to install the battery.
Align the battery with the groove in
blower/vacuum cleaner handle and slip it into
place.
Always insert it all the way until it locks in place
with a little click, If not, it may accidentally fall
out of the blower/vacuum cleaner, causing
injury to you or someone around you (Fig. 5).
○
How to remove the battery.
Withdraw battery from the blower/vacuum
cleaner handle while pressing the latch (2 pcs)
of the battery (Fig. 5).
Handle
Latch
Insert
Push
Battery
(sold separately)
Pull out
Fig. 5
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure
the following points.
○
The power source voltage is stated on the
nameplate.
○
The cord is not damaged.
WARNING
Do not charge at voltage higher than
indicated on the nameplate.
If charged at voltage higher than indicated
on the nameplate, the charger will burn
out.
1. Connect the charger’s power cord to a
receptacle. When the power cord is connected,
the charge indicator lamp will blink in red. (At
1-second intervals)
WARNING
Do not use the electrical
cord if damaged. Have it
repaired immediately.
2. Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger
as shown in Fig. 6.
Charge
indicator lamp
Guide rail
Battery
Fig. 6
3. Charging
When inserting a battery in the charger, the
charge indicator lamp will blink in blue.
When the battery becomes fully recharged, the
charge indicator lamp will light up in green.(See
Table 2)
(1) Charge indicator lamp indication
The indications of the charge indicator lamp
will be as shown in Table 2, according to the
condition of the battery charger or the battery.
12
English
00Book̲RB18DC̲NA.indb 12
00Book̲RB18DC̲NA.indb 12
2021/08/05 16:34:02
2021/08/05 16:34:02
