ENGLISH
13
ENG
Only moderate pressure is required for hammer
drilling. Applying a high degree of pressure does
not increase performance.
When drilling deep holes, remove the drill bit peri-
odically from the hole to remove dust.
When drilling in tiles and other brittle materials:
Set the operating mode to
"Drilling".
The vent slots of the machine should be cleaned
periodically.
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Chargers
B Battery packs with different capacities.
Use battery packs only with voltage suitable
for your power tool.
C Metabo carrying strap
D Tools with SDS-plus shank
E Connecting piece
F Geared chuck
G Twist drills for metal and wood
H Screwdriver bit
I Special grease (for lubricating the tool
shanks)
For complete range of accessories, see
www.metabo.com or the main catalogue.
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.
Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately
and handed in for environmentally compatible
recycling.
Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
U
= Voltage of battery pack
Ah
= capacity of the battery pack
m
= weight
n
1
= No-load speed
ø
max.
= maximum solid drill diameter
s
max.
= maximum impact rate
W
= Single impact force
Vibration total value (vector sum of three
directions) determined in accordance with
EN 60745:
a
h, HD
= Vibration emission value
(hammer drilling into concrete)
K
h,HD
= Uncertainty (vibration)
The vibration emission level given in this informa-
tion sheet has been measured in accordance with
a standardised test given in EN 60745 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of exposure.
The declared vibration emission level represents
the main applications of the tool. However if the tool
is used for different applications, with different
accessories or poorly maintained, the vibration
emission may differ. This may significantly increase
the exposure level over the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Identify additional safety measures
to protect the operator from the effects of
vibration such as: service the
9
Tips and Tricks
10 Maintenance
11 Accessories
12 Repairs
13 Environmental Protection
14 Technical Specifications
17026765_0907 BHA 18.book Seite 13 Mittwoch, 2. Juli 2008 4:51 16
Summary of Contents for BHA 18
