ENGLISH
en
11
O Adjusting nut (10)
P "Quick" clamping nut
For complete range of accessories, see
www.metabo.com or refer to the main catalogue.
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
Any Metabo power tool in need of repair can be sent
to one of the addresses listed in the spare parts list.
Please enclose a description of the fault to the
power tool.
The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Metabo packaging is 100% recycled. Scrap power
tools and accessories contain large amounts of
valuable resources and plastics that can be
recycled.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately and
handed in for environmentally compatible recycling.
These instructions are printed on chlorine-free
bleached paper.
Explanation of details on page 3. Subject to
changes serving technical progress.
D
max
=Maximum sanding disc diameter
t
max,1
=max. permitted thickness of clamping
shank on accessory when using clamping
nut (10)
t
max,2
=max. permitted thickness of clamping
shank on accessory when using
"Quick"clamping nut
t
max,3
=Roughing disc/Parting disc:
max. permitted thickness of accessory
M
=Spindle thread
l
=Length of the grinding spindle
n
=No-load speed (maximum speed)
P
1
=Nominal power input
P
2
=Power output
m
=Weight without mains cable
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~
Alternating current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the emis-
sions from the power tool and to compare different
power tools. Depending on the operating condi-
tions, the condition of the power tool or the accesso-
ries, the actual load may be higher or lower. For
assessment purposes, please allow for breaks and
periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a
h, SG
= Vibration emission value
(surface grinding)
a
h, DS
= Vibration emission value
(disc sanding)
K
h,SG/DS
= Uncertainty (vibration)
Typical A-effective perceived sound levels:
L
pA
=Sound pressure level
L
WA
=Acoustic power level
K
pA
, K
WA
= Uncertainty
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
12. Repairs
13. Environmental Protection
14. Technical Specifications
